Dear Z88 Team,
I can see (in 2.pdf in docu/en/SPIDER) that only Torus Nr. 8 is supported in Z88NL, even with Z88 Aurora V5.
Is there any chance that other axisymmetric elements like Torus Nr. 15 will be available in Z88NL (in later versions)?
Regards,
Akos
Only Torus Nr. 8 for Z88NL?
Moderatoren: ccad, mz15, auroraIco, Lehrstuhl
Re: Only Torus Nr. 8 for Z88NL?
Hello Akos,
unfortunately only the volume elements Hex and Tet, plane stress isoparametric Element no. 7, torus no. 8 and truss 3D no. 4 can be used in the Z88NL.
For later versions of Z88, extensions in material nonlinearity for solid elements are planned and will be further developed.
Regards,
J.Wittmann
unfortunately only the volume elements Hex and Tet, plane stress isoparametric Element no. 7, torus no. 8 and truss 3D no. 4 can be used in the Z88NL.
For later versions of Z88, extensions in material nonlinearity for solid elements are planned and will be further developed.
Regards,
J.Wittmann
Re: Only Torus Nr. 8 for Z88NL?
Hello JWittmann,
OK, thanks for the information.
Regards,
Akos
OK, thanks for the information.
Regards,
Akos