Simulating gravity by forces at nodes

Das Forum zu Z88OS (Open Source) / The newsgroup for Z88OS (open source)

Moderatoren: ccad, mz15, auroraIco, Lehrstuhl

Simulating gravity by forces at nodes#2747

vom TomGroves
#2747
I'm trying to simulate gravity on a 2D object by distributing the force across the nodes (as described in z88mane.pdf, page 97, fig.2). The object is supported by fixed nodes with zero displacement at the bottom.
I'm seeing an odd result:
ForceConcentrate.png (11.63 KiB) 1480 mal betrachtet
Why is the stress concentrated at the corners of the supports? Surely it should be distributed across the base?

Thanks,
Tom
Dateianhänge
(562.43 KiB) 117-mal heruntergeladen

Re: Simulating gravity by forces at nodes#2749

vom DanBil
#2749
Hi Tom,

the stress is very high at the supports, because there are local singularities (high stress gradient within an element). This is a typical phenomenon in finite element analysis. The reason for that is, that a linear finite element analysis can not consider the local plasticization, which would lead to downsizing and shifting of the stresses. Because of that a stress evaluation at the position of boundary conditions should be made in an integral way after a refinement of the mesh.

Kind regards,
Daniel Billenstein

Re: Simulating gravity by forces at nodes#2761

vom TomGroves
#2761
Really? Surely there's no local plasticization when a (relatively light) steel object sits on a hard surface?

Is there a guide somewhere on how to do the refinement and re-evaluation at the singularities? I'm new to FEA, and I was not expecting this complication :-/

Thanks,
Tom

Re: Simulating gravity by forces at nodes#2762

vom DanBil
#2762
Hi Tom,

of course there is local plasticization in reality, but a linear finite element analysis can not consider this effect. For that you need to use a solver for nonlinear material behaviour.
Z88Aurora has one, but only for hexahedron and tetrahedron. So you have to make a new finite element structure with hexadrons or tetrahedrons to consider this effect within Z88Aurora.

Kind regards,
Daniel Billenstein
What are the requirements for Abaqus .inp files to import?

Dear samshah, what CAD system do you use? Maybe y[…]

FORK WRENCH example has no boundary conditions example setting.

Hello Mr. Gillies, the boundary conditions are al[…]

Beispiel2 Kranträger

Vielen Dank für den HInweis, habe zwar alles […]

Vernetzung von .stl-Dateien

Hallo Olegator, es gibt einige Freemesher, welche[…]