### Beginner: problem with simple shaft stress & deflection

Tipps & Tricks ... / How to ...

### Beginner: problem with simple shaft stress & deflection#3344

vom RobinH
#3344
Hello,
I am having two problems with a simple tube in bending moment. One I think is my lack of understanding with the program and the other just has me puzzled.

I have a very simple model with 2 tubes at right angles. One end is fully constrained and a load is applied at the junction.

problem 1: When I run the solver it returns a deflection of zero. If I shift node 3 so the angle is less than a right angle then I get valid results for deflection. This has me puzzled

Problem 2: When I get valid deflection results I do not get any stress results for the elements. I think this might be my lack of understanding of how to use the program.

As per the title I am a beginner to Aurora. Any suggestions appreciated

I have attached the contents of the project directory with the results for zero deflection.

Regards,
Robin
##### Dateianhänge
Beschreibung anfügen

### Re: Beginner: problem with simple shaft stress & deflection#3348

vom FViebahn
#3348
Dear RobinH,

the Shaft No. 5 has to be defined coincident with the global x-axis. It is shown in the element-library, but is not very obvious. For your structure I would recommend using the Beam No. 2, since it has the same degrees of freedom (dof) and the same mechanical properties while not being limited to the x-axis.
For structural elements like beams, trusses etc. the element stresses are not calculated (or rather: shown) for a number of reasons. You can calculate them manually though by looking at the output files generated after the solver has run: z88o4.txt in the project folder.

I hope this helps!

### Re: Beginner: problem with simple shaft stress & deflection#3350

vom RobinH
#3350
Thank you FViebahn,

That has fixed the problem, using Beam 2 now behaves as I would have expected it to.

Regards,
Robin

### Re: Beginner: problem with simple shaft stress & deflection#3352

vom FViebahn
#3352
###### Material Datenbankerweiterung

Dazu gibt es ein separates Artikel im Benutzerhand[…]

###### Fehler: Z88AG2R

Hallo SHautsch, vielen Dank für die schnelle[…]

###### Solid Works 2016 / Es kann nur ein Bauteil vernetzt werden / STL

Hallo Alex, wenns keine großen Umständ[…]

###### Z88 kann nicht gestartet werden: "Gtk-WARNING **: cannot open display" - Mac OS 10.12.6

Hallo Max, alles klar - das hilft natürlich […]