Hello,
I tried to run a simple modal analysis of a beam25 grounded on both tips. Material is steel and I defined density (new material). It did not run and the message is not clear to me...
My configuration : Xubuntu 16.04.2 LTS. Intel i5 4 Go RAM 64 bits.
I add a picture of the files and I tarred the files.
Please let me know if it is an issue with the installation or if I made a mistake in the input.
Note that I ran some of the examples without any issues.
Thank you.
Fabrice.
Modal analysis does not run
Moderatoren: ccad, mz15, auroraIco, Lehrstuhl
Re: Modal analysis does not run
Dear Fabrice,
have a look at theory manual page 117: modal analysis is only possible for element types 1, 10, 16 and 17 (linear and quadratic tet and hex).
Kind regards,
SHautsch
have a look at theory manual page 117: modal analysis is only possible for element types 1, 10, 16 and 17 (linear and quadratic tet and hex).
Kind regards,
SHautsch
Re: Modal analysis does not run
Hello,
Oups ! I missed this...
Thank you !
Regards,
Fabrice.
Oups ! I missed this...
Thank you !
Regards,
Fabrice.