Hinweise zum Import von: / Hints for importing:
STEP, STL, AutoCAD-DXF, NASTRAN, ABAQUS, ANSYS, COSMOS, Z88

Moderatoren: ccad, mz15, auroraIco, Lehrstuhl

vom Marek
#3276
Hello,
I have a problem with imports .dxf, .stl, .step created in the program Rhinoceros.
There is no way I can import files to Z88Aurora - appears unknown error.
Please help solve the problem.
vom KeDee
#3277
Hello Marek,

please upload the files you cannot import so we can have a look at it.

Greetings
KeDee
Benutzeravatar
vom SHautsch
#3279
Dear Marek,

it is not possible to import arbitrary DXF files to Z88Aurora. These files need to be specially prepared in AutoCAD, like described in our theory guide (C:\Z88AuroraV3\docu\en\theoryguide.pdf) on page 76 et sqq.

The STL file could be imported and meshed without problems...please make sure you don't import assemblies - only a single part is supported in Z88Aurora V3.

The STEP file could also be imported and meshed without problems.

Maybe your installation auf Z88Aurora is corrupted? Did you install in C:\Z88AuroraV3\ or in the program files folder? This could produce problems. Also make sure you run it as an admin when you installed as an admin, as Z88Aurora must run its subprograms and needs the appropriate access rights.

Kind regards,
SHautsch
vom Marek
#3280
Hello,
Problem has been solved . The program must be installed and run as admin. Everything works fine ... :)
Thank you very much for your help :D :D
Regards,
Marek.
Benutzeravatar
vom SHautsch
#3281
Dear Marek,

we are glad you could solve the problem. Enjoy using Z88Aurora and come back here if you experience further problems.

Kind regards,
SHautsch

Hallo, vielen Dank, das werde ich ausprobieren mi[…]

Start

Hallo Schlorchi00, leider konnten wir den Fehler[…]

Hallo liebes Z88 Team, gibt es bereits Neuigkeite[…]

UPDATE Nachdem ich es nach weiteren Tests leide[…]