Seite 1 von 1
Import error
Verfasst: Di 7. Feb 2012, 14:32
von Sebastian
I tried to import a step file into Z88 and got the following result:
The same file as an stl imports like this:
Why is the step file not importing properly?
Re: Import error
Verfasst: Di 7. Feb 2012, 22:20
von mz15
Hello Sebastian
Since the STEP converter is open source and does not come from our team, I can not fully answer the question.
However, the converter can handle properly only with the STEP protocol AP203. If your file in STEP AP214 format that can possibly lead to errors.
Sincerely
Markus Zimmermann
Re: Import error
Verfasst: Mi 8. Feb 2012, 06:38
von Sebastian
mz15 hat geschrieben:... the converter can handle properly only with the STEP protocol AP203. If your file in STEP AP214 format that can possibly lead to errors.
Actually I tried both and got the same result
Re: Import error
Verfasst: Mi 8. Feb 2012, 11:41
von mz15
Hello Sebastian
It is possible that even then the STL file generated from the STEP file is corrupt. Unfortunately we have no influence to. But if it works with the STL file, it is at least one partial success.
Sincerely
Markus Zimmermann
Re: Import error
Verfasst: Mi 8. Feb 2012, 12:18
von Sebastian
Thank you.
Re: Import error
Verfasst: Mi 8. Feb 2012, 13:43
von mz15
You're welcome