Hinweise zum Import von: / Hints for importing:
STEP, STL, AutoCAD-DXF, NASTRAN, ABAQUS, ANSYS, COSMOS, Z88

Moderatoren: ccad, mz15, auroraIco, Lehrstuhl

Benutzeravatar
vom mz15
#983
Hello Sebastian

Since the STEP converter is open source and does not come from our team, I can not fully answer the question.
However, the converter can handle properly only with the STEP protocol AP203. If your file in STEP AP214 format that can possibly lead to errors.

Sincerely
Markus Zimmermann
Benutzeravatar
vom Sebastian
#986
mz15 hat geschrieben:... the converter can handle properly only with the STEP protocol AP203. If your file in STEP AP214 format that can possibly lead to errors.
Actually I tried both and got the same result :?
Benutzeravatar
vom mz15
#989
Hello Sebastian

It is possible that even then the STL file generated from the STEP file is corrupt. Unfortunately we have no influence to. But if it works with the STL file, it is at least one partial success.

Sincerely
Markus Zimmermann

Hallo Hanhart94, ich vermute der Fehler liegt bei[…]

Start

Hallo Schlorchi00, leider konnten wir den Fehler[…]

Hallo liebes Z88 Team, gibt es bereits Neuigkeite[…]

UPDATE Nachdem ich es nach weiteren Tests leide[…]