Z88-Forum

Hi,

I am new user Z88 and I have very simple questin.

I try import .step, .stl and .dxf.

When I click OK program start something doing and stop.

Nothing happend, program is suspended:(

Could You help me and explain what I should do?

SORRY FOR ME ENGLISH LANGUAGE:)

dyku,

Dear dyku,

have you defined the respective paths in the toolbar?
> help > options > paths

Normally they are :
STEP-Konverter
c:\z88aurorav1\addons\geocon\win32 resp. win64
TETGEN
c:\z88aurorav1\addons\tetgen\win32 resp. win64
NETGEN
c:\z88aurorav1\addons\netgen\win32 resp. win64

Then click OK and restart Z88 Aurora. For further information on that
see our homepage; at the download page, there is an installation guide
describing this in detail.

Other problem could be, your stp stl and dxf files ar stored in paths
containiing spaces, like "My Documents" or
"c:\Documents and Settings\Username\Desktop"
- if so, copy them to a folder like "c:\temp" without spaces and symbols
like "+,#" etc.
That ought to work!

Have fun with Z88 Aurora!

Regards,
Z81

Hello Everyone

I am new Z88 user and I tried for a while to import step file from solid edge to Z88 aurora, and besically nothing happen, it does not work so I read the manual and I set the directory how easely explain. however the resoult does not change. Anyway I can not go futher than Win32 folder , apparently win64 folder is not there.

How can I solve the problem?

I alredy tried with very simple geometry.

Many thanks

Piccio1979

Hello Piccio1979,

did you take a look to the statusbar of z88Aurora? Only if the message
"### Mistake during geometry import! Please check path to modul z88GeoCon"?
is printed, the module-path is the problem. In this case the executeable z88GeoCon.exe should exist in the path, which you can see in our control-File z88enviro.dyn in the bin-Folder.

Otherwise make sure, that there are no whitespaces in the path of the step-File, as Z81 wrote above.

Hope, I could help you.

Greetings.
Martin Neidnicht