English: DXF import problem
Verfasst: So 4. Okt 2009, 18:17
Dear Z88 forum,
I am just starting with Z88 but unfortunately I do not speak good German. Otherwise, perhaps I could have found the answer to my problem already....
When using Z88X DXF convertor to import a DXF file I have the following problem;
"Z88X.DXF for Z88I1.TXT: first Inputgroup missing or wrong STOP".
So this means that the format of my DXF file is somehow wrong?
Here is the start of my DXF file, which was generated using GiD (CIMNE):
[quote] 0
SECTION
2
HEADER
9
$ACADVER
1
AC1014
9
$ACADMAINTVER
70
0
9
$DWGCODEPAGE
3
ANSI_1252
9
[/quote] ETC........
Does anyone here have experience of importing a GiD project into Z88?
EDIT: I forgot to mention that the same error occurs with the Z88 example files!!!! So I guess, on reflection, that it is not an issue specific to the GiD-generated DXF file!
Thank you for your time!
MfG
Gareth22
I am just starting with Z88 but unfortunately I do not speak good German. Otherwise, perhaps I could have found the answer to my problem already....
When using Z88X DXF convertor to import a DXF file I have the following problem;
"Z88X.DXF for Z88I1.TXT: first Inputgroup missing or wrong STOP".
So this means that the format of my DXF file is somehow wrong?
Here is the start of my DXF file, which was generated using GiD (CIMNE):
[quote] 0
SECTION
2
HEADER
9
$ACADVER
1
AC1014
9
$ACADMAINTVER
70
0
9
$DWGCODEPAGE
3
ANSI_1252
9
[/quote] ETC........
Does anyone here have experience of importing a GiD project into Z88?
EDIT: I forgot to mention that the same error occurs with the Z88 example files!!!! So I guess, on reflection, that it is not an issue specific to the GiD-generated DXF file!
Thank you for your time!
MfG
Gareth22