Beginner: problem with simple shaft stress & deflection
Verfasst: Fr 19. Mai 2017, 01:17
Hello,
I am having two problems with a simple tube in bending moment. One I think is my lack of understanding with the program and the other just has me puzzled.
I have a very simple model with 2 tubes at right angles. One end is fully constrained and a load is applied at the junction.
problem 1: When I run the solver it returns a deflection of zero. If I shift node 3 so the angle is less than a right angle then I get valid results for deflection. This has me puzzled
Problem 2: When I get valid deflection results I do not get any stress results for the elements. I think this might be my lack of understanding of how to use the program.
As per the title I am a beginner to Aurora. Any suggestions appreciated
I have attached the contents of the project directory with the results for zero deflection.
Regards,
Robin
I am having two problems with a simple tube in bending moment. One I think is my lack of understanding with the program and the other just has me puzzled.
I have a very simple model with 2 tubes at right angles. One end is fully constrained and a load is applied at the junction.
problem 1: When I run the solver it returns a deflection of zero. If I shift node 3 so the angle is less than a right angle then I get valid results for deflection. This has me puzzled
Problem 2: When I get valid deflection results I do not get any stress results for the elements. I think this might be my lack of understanding of how to use the program.
As per the title I am a beginner to Aurora. Any suggestions appreciated
I have attached the contents of the project directory with the results for zero deflection.
Regards,
Robin