Problem with generating mesh
Verfasst: Mo 25. Jan 2021, 18:19
Hellow Everone, it's my first post here.
Some time ago I found this application, and i've started learning to use it. Now, after quite long breake I have a problem with generating mesh- while I try to do it I see all the time a notification/error/ that there is Netgen (or Tetgen- depends on which mesher I try to use), and information that "Only one part can be meshed".
Problem concern every model I tried to mesh, even simple cube, from already calculated (a few monts earlier) "project" (I used this cube to check some constrains etc.)
I found information here that it could be due to bad stp files, but files I try tu use were used before, and they worked ok. The same problem is on STP, and STL format.
As I remember I probably tried last time to calculate something as contact, and since then I have not been useing Aurora, until tommorow- where I fund that problem. I also tried to repair program, and reinstal it- both without results. Maybe someone had this problem before, and knowns the solution?
I have Aurora V5 version, working on Windows 10.
/Edit/ I cheked the tetgen/netgen logs in project folder, and there were empty
Some time ago I found this application, and i've started learning to use it. Now, after quite long breake I have a problem with generating mesh- while I try to do it I see all the time a notification/error/ that there is Netgen (or Tetgen- depends on which mesher I try to use), and information that "Only one part can be meshed".
Problem concern every model I tried to mesh, even simple cube, from already calculated (a few monts earlier) "project" (I used this cube to check some constrains etc.)
I found information here that it could be due to bad stp files, but files I try tu use were used before, and they worked ok. The same problem is on STP, and STL format.
As I remember I probably tried last time to calculate something as contact, and since then I have not been useing Aurora, until tommorow- where I fund that problem. I also tried to repair program, and reinstal it- both without results. Maybe someone had this problem before, and knowns the solution?
I have Aurora V5 version, working on Windows 10.
/Edit/ I cheked the tetgen/netgen logs in project folder, and there were empty