Beam Element No. 2 Orientation When using DXF to drive FEA
Verfasst: Mo 4. Dez 2006, 02:26
To whom it may concern,
Your manual says that the local yy axis is parallel to the global XY coordinate system...
However, if I was to draw an element in the direction of global z how do I know which way the elements y y axis points.
I assume that it would default to parallel to the global y axis.
Is my assumption correct?
Best Regards,
Ben Standring
Your manual says that the local yy axis is parallel to the global XY coordinate system...
However, if I was to draw an element in the direction of global z how do I know which way the elements y y axis points.
I assume that it would default to parallel to the global y axis.
Is my assumption correct?
Best Regards,
Ben Standring